Skip to main content

FARMA 5 – 15 C

The FARMA-N 5 – 15 C tractor processor is an extremely versatile appliance and all foresters will appreciate its potential. It improves capacity and boosts forest output by minimizing the area lost to strip roads. It will also handle the heaviest and most dangerous operations at very reasonable investment cost.  

After the trees have been felled manually, the processor winch simply hauls them in. The processor is then used for handling, limbing, bucking and sorting the timber into different piles.

FARMA-N is simple to handle, is reliable and easy to service. It is a sturdy machine that can manage anything from initial clearing to final felling of trees with stem diameters of up to 50 cm.

The FARMA-N 5 – 15 can easily be hitched to any agricultural tractor. The processor has its own hydraulic system, which is driven by a robust pump and there is a gearbox designed for connecting directly to the tractor power take – off, which eliminates the transmission shaft. 

FARMA-N has a high capacity and features a number of technical refinements that enhance its working efficiency. The FARMA-N 5 – 15 is equipped with a powerful hydraulic winch. Hauling-in can be controlled either remotely by radio control or locally from the control panel. The winch effort is 2,5 tones. Other features include for example a built-in boom extension cylinder with damping at both limits of travel, built-in saw with integrated lubricating pump and fixed saw motor, large 60-litre hydraulic oil tank and one adjustable control panel for optimum working position. 

FARMA-N 5 – 15 C is described as an automatic version equipped with length and diameter meters as well as a steering system with nine pre-selection options. The length of the cut can be chosen with either plus or minus bottoms on the maneuvering panel. Manual pre-selections can still be chosen. 

For further information about FARMA-N 5 – 15 C download the brochure.

Weight (Kg) 1050
Length (mm) 2000
Height (mm) 2300
Width (mm) 2450
Chain bar (") 18
Saw capacity (kW/hk) 18/25
Chain partition (") 0.404
Chain speed (m/sek) 40
Working angle (°) 75
Lenght winch wire (m) 40
Diameter winch wire (mm) 8
Max. Pulling power hydralic winch (ton) 2.5
Max. Lumber diameter (mm) 500
Stroke lenght stroke feeder (mm) 1520
Average speed stroke feeder (m/sek) 1.5
Delimbing pressure (MPa) 11.0
Nominal hydraulic oil flow (l/min) 60
Nominal PTO speed (r/min) 400
Power need (kW/hk) 30/40
Electrical provision 12V-16A
Volume hydraulic oil tank (L) 65.00
Type of oil - Hydraulic oil Hydraulolja 32
Type of oil - Gearbox Hypoidolja 80/90, 0,4 l
Radio control

Do you need more information?

Tom Belton International salesman Phone: +44 7860 951485

Contact us


Tule 30, 765 05 Saue, Estonia